Honda TRX700XX Forum - Club700XX banner
1 - 3 of 3 Posts

·
Registered
Joined
·
34 Posts
Discussion Starter · #1 ·
Can you bore stock jug to 104mm. Has anyone done it. I found sleeve is 3.5mm. That only leaves 1.5mm. Is that enough.
 

·
Super Moderator
Joined
·
5,860 Posts
Yes it can be done, but why not go to 103 1st and leave more room?

Sent from my SM-G930T using Tapatalk
 

·
Registered
Joined
·
34 Posts
Discussion Starter · #3 ·
I found sure it can be done. But specs call only to go .25 mm over. So 2.0 mm. Not happening. The reason was I found a really good deal on a weisco piston.
Got jug back it’s warped. I can order stock piston they sell oversized .25mm. But I think I will just do stock new jug and piston. Thanks for the reply. I thought this site had died.
 
1 - 3 of 3 Posts
Top