Honda TRX700XX Forum - Club700XX banner
1 - 1 of 1 Posts

· Registered
9 Posts
Discussion Starter · #1 ·
Hello, I am using the Factory Service Manual to replace the left outer CV Boot on my 700XX and I am to the point where I need to take off the nut holding the left axle shaft. Does anyone know what size socket I need to take that off. It is pretty large and I am figuring I will need to go buy one but wanted to make sure it is the correct size. Thanks for your help.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.