Honda TRX700XX Forum - Club700XX banner
1 - 5 of 5 Posts

·
Registered
Joined
·
182 Posts
Discussion Starter · #1 ·
So I have a dilemma. I want to keep the all black look with the PRM bumper, rear grab bar, and foot boards, however I am thinking if I get them powder coated black they eventually will be all scraped up looking.

Anybody have any PRM stuff powder coated and have this issue?
 

·
Registered
Joined
·
182 Posts
Discussion Starter · #2 ·
WOW don't everyone say so much at once here
 

·
Registered
Joined
·
425 Posts
Dont matter what brand you get, its all going to get scrapes and dents from riding.

PRM makes good stuff, and even has been tested on this site....but im sure you aleady know that.

now get out there and ride!
 

·
Premium Member
Joined
·
553 Posts
If you are concerned about it staying pretty, don't ride it! That is the reason I didn't go with powder coating on my nerfs and bumper, I knew they would look like crap after a few riding trips.
 

·
Registered
Joined
·
2,171 Posts
I just rode with freshly PC'd black wheels and they didn't get near as scratched up as I thought and I rode it harder than I ever have.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top