[smo0oth1]

Would anyone know what ohm the SCS Connector is for our bikes? It's the jumper wire to reset the TPS. It may not even be a specific ohm, Any info would be great.

http://bore-tech.com/catalog/hondas...age=0&osCsid=3ed4292c88a35830e93f705217359eff

 

[crwh45]

If I knew where/what wire you were talking about, I could take my fluke to it as my bike is tore apart now, that is if I can get to it w/ out tearing more stuff apart.

I see now that I should've looked at the link. Do you know where it is located and what they are measuring the resistance of? End to end?

 

[smo0oth1]

I need the measurement of the "tool" resistance.

 

[scuzz]

Why not just buy it and it'll be there when you get back from Offshore?

http://www.boats.net/parts/detail/honda/H-070PZ-ZY30100.html

$18

http://www.lawnmowerpros.com/detail.asp?id=070PZ-ZY30100

$13!

The people in this thread used a paperclip, so it makes me think it's zero ohms.

Same thing with this thread.

 

[smo0oth1]

I ordered one about noon, I tried using a bare wire but it wouldn't reset.

 

[scuzz]

Sorry man.

 

[smo0oth1]

All good.... Appreciate the help

 

[qqac]

Hi Smo0oth1,

Did you ever get the SCS connector (070PZ-ZY30100) and have you measured the resistance of the connector and figured out any other specs necessary to replicate it for a DIY solution? Is it correct that the tool only jumps the bottom 2 wires (with the tab on top) and the other 2 are dummy plugs? Thanks for any info!