Honda TRX700XX Forum - Club700XX banner
1 - 5 of 5 Posts

·
Registered
Joined
·
367 Posts
Discussion Starter · #1 ·
Hrmmm Working my way down the Manual for removing head.

Asking me to remove cam chain tensioner lifter bolt and sealing washer. ok easy enough.

Then it says to rotate the tensioner shaft clockwise fully and stop it with the "special tool"

wtf do i get one of those.....
 

·
Premium Member
Joined
·
1,073 Posts
skinny screw driver, but you only really need to do that when reinstalling the tensioner. just take the two mounting bolts out and pull the tensioner out, two 8mm head bolts i think
 

·
Premium Member
Joined
·
1,073 Posts
Take all the bolts out and then bump the side of the cover with a dead blow hammer to break it loose there isn't a gasket for the head cover it's just siliconed to the head
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top