Honda TRX700XX Forum - Club700XX banner
1 - 6 of 6 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Sup guys. I'm here because a member on the raptor forums asked me to make a bolt pattern drilling jig with the 144 pattern for you guys. Well, I picked up the prototype today and should have my first batch done next week. Jig will have 4/156, 4/144, 4/143, 4/137, 4/115, 4/110, and the jj&a 3 spoke hub bolt pattern.
I do have a few on hand but they don't have the 156, 144, 143, or the jj&a bolt pattern.

Here are some pics of the protoype.



 

·
Registered
Joined
·
4 Posts
Discussion Starter · #2 ·
Ok so I have these on hand but we made a change; 143mm was replaced by 137mm.

The main reason I got these done was for people with jj&a 3 spoke hubs that want more than one set of tires but don't want to spend $$$ to buy the custom wheels; and for the sxs guys. You can also use them to drill honda (144) wheels to yamaha. But I'm not sure the center hole on the 144mm wheels will clear the tabs on the oem hubs, that's if the hubs have tabs, if not then the 144 wheels will fit w/ out modification. The 144mm pattern will not fit on the 156mm wheels I have here; they are not douglas though.

The jigs are laser cut and made out of 1/8" steel, unlike the rear jigs which were made out of 1/4" steel. By doing the cost drop a bit, and I'm passing those savings to you. The jigs have 156, 144, 137, JJ&A, 115, and 110.
Price is $36 shipped. If you recently bought a rear jig you can have the front ones for $32 shipped.


Here's a pic of my quad with regular wheels drilled with the jj&a bolt pattern.
 

·
Premium Member
Joined
·
723 Posts
u may have better luck if you put this in the for sale section. no one reads the new members section.
 
1 - 6 of 6 Posts
Top