Honda TRX700XX Forum - Club700XX banner

Transmission rebuild 700xx

2K views 2 replies 2 participants last post by  cataway 
#1 ·
I am rebuilding the transmission on a 2008 Honda TRX 700xx. My question is how do I get the two snap clips to engage correctly on the main shaft of the transmission? The service manual illustrates that the clips align with a groove on the shaft, but I am having difficulty getting it to do so. Appears the snap clip needs to engage on the open ends so it will not turn on the shaft.
 
#2 ·
I don't know but I am going to find out . I to am redoing the trans. its jumping back and forth from 3 and 4 th gears have been ordered and the drum also ordered the snap rings ….just in case I need them
 
#3 ·
what went bad that you needed to rebuild the trainee ?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top